How to reset Hot Springs spa WiFi?
Hard reset – turn the spa off at the breakers, get a tiny phillips head screwdriver and take the little screws out of the back of the remote and remove the battery. Turn the spa back on, let it reboot, and then insert the battery back into the remote and see if that fixes it. Look for a small reset button on the back of the remote or inside the battery compartment. Use a paperclip or a similar object to press and hold the reset button for a few seconds. Then, try pairing the remote with the TV again. Hello!
How do I reset my Hot Springs spa control panel?
Initially, try pressing the screen and holding it for 20-30 seconds. This may reset the wireless remote. If that doesn’t work, you should unscrew or remove the battery from the remote for 10-15 seconds. This action will reset the wireless remote and allow it to sync with the tub. If your hot tub won’t connect, try restarting both devices, ensuring they are within range, updating firmware, resetting Bluetooth settings, and checking for interference. If problems persist, refer to the user manual or contact customer support.
How do I unlock my hot tub control panel?
To deactivate the SPA LOCK, press the LIGHT minus (-) and TEMP minus (-) buttons at the same time and hold them down until the word SPA and the lock symbol are no longer illuminated on the display (approximately two seconds). To unlock your Hot Spring spa controls, first locate the control panel’s lock button or combination (often holding ‘Jets’ and ‘Light’ buttons for 5 seconds). This disables the control lock feature. If unavailable, power cycle the spa by turning off the breaker for 30 seconds, then restart.
How do I reset my circuit board on my hot tub?
To reset a hot tub control panel: turn off the power at the breaker for at least 30–60 seconds, wait for the internal memory to clear, then restore power. Some touchscreen models may require pressing and holding the power or menu button to reboot the system. For an unresponsive Clearwater hot tub touch screen, first perform a system reset by powering off the unit completely for 5 minutes. Check the control panel ribbon cable connection for looseness or damage. Inspect the circuit board for moisture or corrosion, which can cause erratic behavior.Hot Tub Wiring Requirements If you’re wiring a 240V hot tub, you’ll need a 4-wire cable consisting of two hot wires, a neutral wire, and a ground wire. For a 120V hot tub, you’ll need a 3-wire cable consisting of a hot, neutral, and ground wire.Key Takeaways. Hot tubs need a 240-volt, 50-amp circuit and copper wiring (6-gauge for 50 amps, 8-gauge for 40 amps). Install a GFCI breaker and place electrical parts at least 5 feet from the tub for safety.Most hot tub power failures are caused by tripped breakers, GFCI issues, clogged filters, or air locks – all fixable problems. Know when to stop and call a professional to avoid safety hazards or expensive damage to your system.