Why is my spa controller not working?
Examine the cable for any crimps or visible damage. Clean the plug-in cable connections on both ends. Check the power at the transformer on the control circuit board. Verify the power at the fuse on the spa control circuit board. Ensure that the topside control number is compatible with the spa control chip version. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
Why did my spa stop working?
There are several possible reasons why spa jets are not working. It may be due to a faulty circulation pump, clogged filter, or water intake issues. If some jets are working fine, there might be chemical damage or calcium build–up to those that are not working. Why is my spa not heating? Make sure: The water is at a level which covers all of the jets as this affects the water flow through the heater. The filter has been cleaned within the last four weeks by soaking it in BEAR STRIP FILTER CLEAN and that filter is not older than 18 months.
Why won’t my spa turn on?
If your hot tub is not turning on, there could be a problem with the hot tub’s electrical supply or the hot tub’s control panel. First, check the hot tub’s breaker and ensure it is not tripped. Next, check the hot tub’s control panel to see if it is functioning properly. If the hot tub control panel remains unlit despite power, first verify the main breaker and GFCI are reset. Inspect the low voltage transformer supplying the control board for output voltage. Check wiring connections between the control panel and circuit board for loose or corroded terminals.No power to the control panel One of the most obvious signs of a blown hot tub fuse is a complete lack of power to the control panel.Check the Circuit Breaker The first thing to check when your hot tub has no power is the circuit breaker. Locate the breaker box and check for any tripped breakers. If the breaker for the hot tub has been tripped, reset it by flipping it to the off position, then back to the on position.
How to troubleshoot a spa?
If your hot tub temperature is all over the place, you could have water flow problems. Start by cleaning your filter, checking for circulation blockages, and topping off your water if necessary. Check whether your pump turns on. Your pump has to be running in order for the spa to heat up. For an unresponsive Clearwater hot tub touch screen, first perform a system reset by powering off the unit completely for 5 minutes. Check the control panel ribbon cable connection for looseness or damage. Inspect the circuit board for moisture or corrosion, which can cause erratic behavior.